Setting-blocks
Cross Section | Part Number | Description | Link |
---|---|---|---|
![]() |
Anti-Walk Side Spacers (W Blocks) 80 +/-5 Durometer EPDM | Anti-Walk or “W” spacers are used on the perimeter of storefront glass to prevent “walking” due to vibration, temperature and wind variation. Glass to metal contact leads to breakage and subsequent air and water leakage. The Anti-Walk or “W” spacer is self-supporting and prevents this from happening. Available with 1/8″ Wall, other sizes are availableRead More |
Read More |
![]() |
Clear Mirror Setting Blocks | Custom sized Setting Blocks are available. If you don’t see your required size of block, please call for pricing. |
Read More |
![]() |
80 +/-5 Durometer EPDM/Silicone Rolls | As a general rule, setting blocks should be centered at 1/4” points. However, engineering requirements may dictate an alternate location for block placement. Setting blocks should be designed to prevent shifting, provide life long support of the full thickness of the in fill, establish minimum recommended bite and edge clearance, allow for the flow of water by the block to the drainage system, and provide for the installation of glazing seals and assembly of the system. Custom sized Setting Blocks are available. If you don’t see your required size of block, please call for pricing. |
Read More |
![]() |
80 +/-5 Durometer Santoprene Setting Blocks | As a general rule, setting blocks should be centered at 1/4” points. However, engineering requirements may dictate an alternate location for block placement. Setting blocks should be designed to prevent shifting, provide life long support of the full thickness of the in fill, establish minimum recommended bite and edge clearance, allow for the flow ofRead More |
Read More |
![]() |
80 +/-5 Durometer Silicone Setting Blocks | As a general rule, setting blocks should be centered at 1/4” points. However, engineering requirements may dictate an alternate location for block placement. Setting blocks should be designed to prevent shifting, provide life long support of the full thickness of the in fill, establish minimum recommended bite and edge clearance, allow for the flow ofRead More |
Read More |
![]() |
80 +/-5 Durometer EPDM Setting Blocks | As a general rule, setting blocks should be centered at 1/4” points. However, engineering requirements may dictate an alternate location for block placement. Setting blocks should be designed to prevent shifting, provide life long support of the full thickness of the in fill, establish minimum recommended bite and edge clearance, allow for the flow ofRead More |
Read More |