80 +/-5 Durometer EPDM/Silicone Rolls

As a general rule, setting blocks should be centered at 1/4” points. However, engineering requirements may dictate an alternate location for block placement. Setting blocks should be designed to prevent shifting, provide life long support of the full thickness of the in fill, establish minimum recommended bite and edge clearance, allow for the flow of water by the block to the drainage system, and provide for the installation of glazing seals and assembly of the system.

Custom sized Setting Blocks are available. If you don’t see your required size of block, please call for pricing.

This product is currently out of stock and unavailable.

SKU: N/A Category:

Additional information

Dimensions 4 × 1 in
Width

1-1/2", 1-1/4", 1-1/8", 1", 1/2", 1/4", 3/4", 3/8", 5/8", 7/8"

Thickness

1/16", 1/2", 1/4", 1/8", 3/16", 3/8"

Length

4 ft, 50 ft